@butchalline wrote:
Noob needs help:
Cannot do calibrations in Mission Planner, suspect wiring between PixRacer and Rx. I have followed this suggested wiring:PR FRS port to X8R Smart port
Blk to gnd
Red to plus
Grn/yel to sig (note tied together on X8R signal pin.)Setup:
PixRacer frimware = APM:Copter 3.4.2
Mission Planner firmware = 1.3.41
Taranis Tx firmware = 2.1.9, model X9D
Rx Model X8R (D=16, firmware unknown, early model)Questions:
1. Has anyone successfully used this wiring setup?
2. How would I wire up for S-Bus?
3. How would various wiring schemes be tested off of the vehicle?Thanks for your help
Posts: 3
Participants: 3
