@funjet2 wrote:
Hello. I am running MP 1.3.43 and Pixhawk hardware with 3.7.1 firmware.
Tonight I had an experience that has not happened before. I was previously running MP 1.3.42 and same Pixhawk 3.7.1 firmware, and when connecting via telemetry radio I get the message "Getting Params 1" in a pop up window. As soon as that operation successfully completed the screen refreshed and all of a sudden a new pop up window appeared with the message "Getting params 12" and it stays there forever unless you press the cancel button, and then the screen refreshes, you are connected and everything works fine from that point forward. I have also tried connecting over USB and got the same results. I noticed there was a MP 1.3.43 update available so I updated and tried connecting again via USB and also telemetry radio, and got the same results. This has never happened to me before, so I'm wondering if I have a setting that's been changed incorrectly or if this is a bug. I've never seen the message "Getting params 12" before, so either it never does that or it goes by so quickly I have missed it. The only other thing I have updated besides MP is my minimosd_extra screen settings. Any assistance is appreciated. If I have placed this post in the wrong category plz let me know. Thx
Regards
Mike
Posts: 3
Participants: 2