@surbi80 wrote:
Hy @ all,
I have a F450 Frame with a new Pixhawk 2.1.
I have installed a Lightware SF11 rangefinder connected over telemetry 2 port ( serial ).
When i switch to altitude hold the copter does not stay on a certain height. Maybe for a few seconds but then it starts to change for about 40 to 50 cm and goes back on the height i selected altitude hold. When i watch the video on the ardupilot wiki webpage it is much more stable. i have tried different selections on the sensor but with no effect. Maybe some of you guys can share the settings with me ??? I'm new to this and i have lots to learn...Thanks in advance...
Jan
Posts: 1
Participants: 1