@Ktrpilot wrote:
Hi all If there is a grand wizard out there who might be able to help It'd be greatly appreciated. I've run into a few issues trying to set up a minim OSD running Night Ghost firmware and an EZ UHF on a traditional Helicopter running 3.4. The biggest issue I have is that with traditional heli, channel 8 is already assigned for throttle, where through the config tool for the the minim OSD channel 8 is the only option available for reading RSSI from the receiver, the third leg to the issue is that with EZ UHF to get RSSI through ppm you have to assign the channel (which I'm guessing has to be channel 8) you want to carry across the RSSI or link quality information. Is there any way to use a different channel for either RSSI on the minim OSD or for throttle on traditional Heli?? The other issue I'm having (it could be related to the first) is that when humouring the system and ignoring the throttle issue for a moment, just to see if I can get it working through channel 8, I'm not getting any reading for RSSI at all on the screen. It just reads flat 0 even when switching to raw values to read the extremes for when the radio is on and off to find the end points of the range. All it shows is 0. Has any one else used minim OSD with a traditional Heli, EZ UHF and a Pixhawk? No doubt there is probably something I have missed in the config tool for the minim as well so any wisdom that could be imparted would be hugely appreciated.. I understand that this monster I have been presented with is one with many heads covering a range of topics, which makes it hard to place so apologies if not all of it is relevant here.
Many thanks in advance.
Posts: 3
Participants: 2