@varesa wrote:
After I got the right firmware installed in http://discuss.ardupilot.org/t/solved-3-5-0-rc4-looses-frame-type-on-reboot/16434/4 and calibrated my sensors I could finally arm the copter (well, almost).
I press the safety switch, make sure that the motor interlock switch is in the right position and give the stick command for arming. I get the beep/armed light and GCS says ARMED except about a second later it disarms itself with no messages to the GCS. I can't get the motors to spin during that second either.
Has anyone else encountered anything similar?
Posts: 5
Participants: 3
