Hi guys.
I got my hands on a very old Drone (DJI Flame Wheel F550)
I has a Arduino based controller in it. It is from DIY Drones (The Hotel 1.0)
Looks like this (APM Oilpan Rev. H, Version 1.0 now in production! - Blogs - diydrones)
It sits on a red Ardupilormega board. This is basically the setup as shown on this page:
https://www.researchgate.net/figure/Telemetry-kit-a-autopilot-ArduPilot-Mega-2560-and-GPS-Media-Tek-b-sensor-board_fig4_275885998
When I power it from the USB I can see the lights come on and the system boot up. However I have absolutely no idea where to check if it is working.
I need help with connecting the wires and programming the system since all the wires are plugged out. Not sure what is missing.
Can someone please point me in the right direction.
Here are some pictures of the controller and other boards that I have.
Any help will be greatly appreciated.
2 posts - 2 participants
