@Donald_Lear wrote:
The Airspeed Sensor is mounted to a air data probe on the tip of the wing. The Pixhawk is mounted in the fuselage of a biplane. In order to transmit the voltage, I spliced the I2C cable to make homemade extensions. Continuity is constant across the circuit, but when I look at mission planner, I get a static number for airspeed. I've tested with another unmodified I2C directly connected to the sensor, and that gets me readings.
I haven't seen any breaks in the wire. The voltage goes through, but no value is read by the Pixhawk. What could be causing this problem?
Posts: 1
Participants: 1