@Amozov_x wrote:
Hello!
Mission Planner 1.3.62. Firmware 3.6.3.
Faced calibration problem power module.Autopilot original. Power module is original. There are no problems with voltage. The current can not be set up. I interchanged all the Mission Planner versions, I interchanged all the settings. I chose others and 3DR power module. Either the current does not change at all in the window. Either does not show. I can not understand what the matter can be.
When I put the measured value. It calculates. And the calculated value does not change.
Posts: 1
Participants: 1