I can not control Yaw of my quad copter via radio stick

@Rolf1 wrote:

Hi,
I can not control Yaw of my quad copter via radio.
I’ m using the controller Pixhawk with the firmware ware 3.3.3.

I have following tested
- Stabilize Mode
- Alt Hold Mode
- Loiter Mode
- RTL
- Auto Mode together with Circle
All modes are working in normal, simple and super simple.
It is real fun.

But I cannot control yaw with my radio. If I use the yaw-stick during flight, the yaw of my copter doesn’t change. At Mission Planner Status h4in is shown that the yaw value is changing with the yaw-stick movement.

I am sure that I have made a wrong input.
After I could not solve the Problem, I have reset the firmware together with the parameter und changed
- Extneded Parameter, the copter is a little bit over controlled, but no problem
- Advanced Parameter, I have changed battery Volt and Current parameter
- some radio parameter adaption
That means not very much.

But the problem with the yaw control remains.

Perhaps someone had the same problem and got help.
Perhaps he will help me

Thank you for your help.

Posts: 1

Participants: 1

Read full topic