@gurrta wrote:
Hello everyone.
It might be difficult to understand because it is posted to the English translation of the Japanese, but thank you about the advice.
The drone of GUBA QW350 you have already connected the APM planner 2.0.23.
PC OS in the MAC is 10.12.
If you choose APMcopter V3.3.3 from install fimware comes out the following message.「no valid device found.
check to be sure your APM2.5+or pixhawk/px4
device is plugged in, and drivers are installed.」Do I How the correspondence?
The QW350 and MAC of the connection are using the FT232RL,
numbers, or the like to the Primary Flight Display if CONNECT is displayed.Also it the following message which together with the above message appears,
but read up to 100% When you select the OK is done, you will not work as it is.「you are about to install arducopter-v2.px4 for px4-quad.」
Firmware Upload com port How can choose if the, thank you much for your professor.
Posts: 8
Participants: 3