@propflux01 wrote:
I don't know if I am in the right place or not, This is my first post here, and my first experience with Pixhawk. I posted on another forum and was directed here. the following is my issue:
Hello,
Have my frame up and ready for flight testing. I am using PIXHAWK 2.4.8. The only things external at the moment is GPS module. I ran the wizard in MP. I can get the system armed, motors will start, throttle up and down just fine, but no matter where my throttle sits, if I move the right stick the unit will shut the motors down within 5 seconds. if I do not move the right stick it will allow the motors to run as long as I want them to There is obviously no way I can fly the unit like this, and since this is my first PIX, I am at a loss as to what to look for or why its doing this. When I hooked up to MP, I updated that first, then went through wizard for the setup. I have assigned no other channels at this time ( I need to figure out gimbal and retract switches later). I can immediately re-arm the system and it will repeat the problem over and over.I am running 4s battery,
Taranis TX
X8R RX using S-BUS
Tiger 3508 380Kv motors
ARRIS 30A ESC (Simon k)AS stated, unit will arm and disarm as advertised, just cannot move the right stick without a shutdown of total system after about 5 seconds, no matter where my throttle stands or where I move the right stick. Props are off during this testing. Can anyone shed some light on what the hell I am doing wrong here? This is becoming very frustrating considering all the kudos about the PIXHAWK system.
And yes, I have googled everywhere to try and find this, with no solution.
Posts: 3
Participants: 2