@wicked1 wrote:
Would it be possible to support 16 PPM channels?
Is anyone else interested in it?
Could the extra two be passed through to unused motor ports?
Even the ability to assign 1-10 to internal commands, and pass through the last 6 would be helpful in comparison to the 14 channels available now.(I've got a copter with two gimbals, landing gear, lights, various internal commands (RTL, MotorStop, Auto, etc), and am using 16 channels. I'm looking at using the new RFD900 modem w/ RC passthrough, but then the pixhawk will need to decode all 16 channels, rather than having a traditional RX doing 9-16)
So, I'm curious if others are using so many channels, and if there's any hope of it being supported by arducopter at some point in the future.
Thanks
Posts: 1
Participants: 1
