@nikker wrote:
Hi, just converted my system from pixhawk to pixhawk 2. I tried connecting my airside rfd900+ to telem 1 and telem 2 and can not get it to work. The radios show they are connected, led solid green, and both telem 1 and 2 are set at 57600 and RTS/CTS disabled. Same setup still works on my pixhawk. Tried to flash plane and mission planner will connect and I cant see the messages you normally would see on first startup like bad compass and no rc receiver but it never gets the parameters and disconnects. Tried with 3.4.3 and 3.4.2. Not sure what I can do next. I did have telem 1 hooked up to a rapberry pi 3 and mavlink worked over UDP.
edit. it is currently powered by USB to my desktop and connecting with a surface pro 3 with the RFD900+. Not sure if that matters but it always worked on my original pixhawk.
Thanks for any help!!
Posts: 4
Participants: 2
