@jtroutt19 wrote:
I just replaced my 2216 920 kv motors on my quad with some 4114 330kv motors. I redid the esc calibrating using the pixhawk just in case.
First question. So I plug in battery wait for flight controller. Depress red safety button hear escs beep. Yaw right to arm get the tone. I have the motor spin at arm disabled. So I go to throttle up motors start increase throttle and can hear the motors increasing in speed up to about 50-60% throttle range. No change in sound or pitch amp draw after that point. I am doing all this with propeller off if that effects anything. I was thinking is could but wanted to make sure.
Second question. I am using Afro 30a opto ESC with blheli flashed. So it supports oneshot125. Anyway. If I set MOT_PWM_TYPE to 2 reboot and then try and throttle up my motors either one will spin or they wont spin at all. I dont get the arming beep either when pressing the safety switch. If I wait a minute or two I might get a arming beep from one or two motors. but never all of them. What is going on here?
Posts: 4
Participants: 2
