@Obecny wrote:
(yes I know there is no such a thing like pixhawk 2.4.8)
I have two pixhawk clones both marked as 2.4.8 versions, everything working perfect as long as the firmware for the copter is 3.2.1 or lower - if I flash it with 3.3.3 or 3.4.3 or 3.4.4 rc1 there is a serious problems - first of all throttle stick increasing the speed of motor only up to half way of the stick, the upper half has no impact for speed of the motor (dead zone) when I try to move the right stick (mode2) it controlling the speed of the motors but sooner or later I will get CRASH and disarming (all this at ground testing without any propellers of course)
I have 6x afro 30a simonk with 6x quannum motors 475kv all of it working perfectly with v3.2.1 on both pixhawk units I have, I believe it could be some firmware bug but I don't know where to go with it so starting here, it could also be some hardware problem as my two pixhawks are identical units.All this is completely new subject for me so really appreciate any help. thanksPs. another thing worth to mention is during esc calibration throttle stick working all way bottom to top and changing the motor speed as it should with no problem at all.
Posts: 1
Participants: 1