@seprice40 wrote:
So I have a new issue of my rear servo (channel 7) not returning to centerline when I deflect the servo to the left or right and let the stick return to center. For example I will go full left deflection (PWM output~1000) and it will return with a little left tilt (PWM output will read ~1400). And the same will happen for the right (PWM full right ~2000 and will return to ~1600)
This started happening after I updated from firmware 3.3.1 to 3.4.4.
I have tried diagnosing mechanical problems and electrical problems but I do think it is due to some parameters that I may not be familiar with!
Thank you so much for the help!
Steve
Posts: 3
Participants: 2
