Pixhawk2 no servo output

@weliwarmer wrote:

I'm having problems getting any output to the servos or ESC. I suspect it's a arming error but can't see anything in the logs.

[MAV 001:1] ArduPlane V3.8.0beta2 (5baf37f7) 
[MAV 001:1] PX4: 3df5644c NuttX: be6ff61a 
[MAV 001:1] PX4v2 00210033 34355111 38393730 
[MAV 001:1] u-blox 0 HW: 00080000 SW: EXT CORE 3.01 (107900) 
[MAV 001:1] EKF2 IMU1 is using GPS 
[MAV 001:1] EKF2 IMU0 is using GPS 
[MAV 001:1] Throttle armed

I've changed the ARMING_CHECK to 0 and tried again but no luck. All mandatory setup done. The Edison companion board is running APSync which works well to connect to APM Planner over wifi. I've added tape to the Pixhawk Cube and changed SERVO5_FUNCTION=33, SERVO1_FUNCTION=0 as per the Service Bulletin. Currently using ArduPlane 3.8.0beta2 but it does not work with 3.7.1 either.

Is there something that I've forgotten?

Thanks,
Tim

Posts: 4

Participants: 2

Read full topic