3.5.0-RC2 On Heli with Pixracer- Can't Clear Motor Interlock

@lasakro wrote:

This is a new setup of a real Pixracer from AUAV stuck to a heli Accel, compass, voltage current, and RC calibrated. Servo 1 channel reversed. SERVO5_FUNCTION=31 for my HeliRSC. I can't clear the Prearm: Motor Interlock Enable.

I then setup CH7_OPT=32 for enabling the interlock. All other CHx_OPT's are 0. Again calibrated my radio to include ch7. Still no change with the channel high. Also check low for the heck of it. What am I missing?

BTW: No external FBL controller like the Microbeast. I read that some folks use both but don't understand why. I took mine off and was the purpose of this new project.

Posts: 2

Participants: 2

Read full topic