@kk6axq wrote:
I just started out using ArduPlane 3.7.1 on a Pixhawk. I have it setup on a FliteTest Explorer with 3 channel + flaperons. I was able to setup the firmware and configure the flaperons with no major issues. When I flew the plane, I took off in Manual mode with no problems other than a little wind. When I switched to Stabilize mode, the plane yawed up and down a lot, changing >10 feet in altitude each dive or climb. I quickly switched back to Manual and was able to land. When I launched again(in Manual mode) and, once flying, switched to FBWA mode, the same result occurred. As a result of these movements and my corrections, I ended up folding the wing. I've attached the log of the two flights, could someone please tell me what I'm doing wrong?
Setup:
FT Explorer with Sport winghttps://www.flitetest.com/articles/ft-explorer
Emax GT2215/09 motor
9x6 prop
Pixhawk running Arduplane 3.7.1
3DR Power Module
3DR uBlox GPS/Compass module2017-04-23 15-50-47.bin (3.2 MB)Taranis X9D with X4R SBus receiver
Thanks,
kk6axq
Posts: 1
Participants: 1
