Hello,
I’m new with flight controllers and Ardupilot but making great progress so far with the help of the wonderful community and documentation.
I’m trying to get the OSD working, but after fiddling with it for hours, I’m throwing in the towel and asking for help. The video works fine, but I can’t get the OSD to appear.
- I’m using a SpeedyBee F405 Wing Flight Controller with Ardupilot 4.5.7.
- I have a Walksnail Avatar HD Mini 1S Kit VTX and camera combo (38.43.13) connected to Serial 5 - SpeedyBee docs call this the “Digital VTX” port but I’ve also tried on the “Analog VTX” port with no success.
- The goggles are a Walksnail Goggles L.
The VTX powers up just fine and transmits to the goggles. I have the TX connected to the RX and the RX connected to the TX between the VTX and the SpeedyBee flight controller. The 2nd GND (2nd black wire) and SBUS (yellow wire) are disconnected.
I’m using the following configuration:
OSD_CHAN 0
OSD_OPTIONS 1
OSD_TYPE 3
SERIAL5_BAUD 57 (but also tried 115)
SERIAL5_OPTIONS 4
SERIAL5_PROTOCOL 42
I have 3 OSD screens enabled in Mission Planner. I don’t know what else to do to get the OSD working and I would appreciate any help.
Thank you!
2 posts - 2 participants