@netptl39 wrote:
Hi all,
I am having a bad gyro crawl on one of my pixhawks running v3.5 and v3.6.
I have up and downgraded several times the firmware and still have the issue.Sometimes it forgets to calibrate at startup. When it calibrates "gx mean:" starts at 0 and crawls to 20-40 within 20 minutes and in rare cases it crawls to about 3-5 and stays there.
All other axes stay at 0.This is a bare pixhawk on the table without any peripherals, connected to the computer via USB cable. On-board mag calibrates at 175, 504, 143
What is causing the problem?
Is the gyro dead?
can AP 3.x fly with 1 gyro?Many thanks in advance!
Tom
Posts: 1
Participants: 1
