@raphh wrote:
Hello,
Helping a friend with a Pixhawk clone (rtfhawk). Upgraded to 3.6, now airspeed sensor is stuck at 5mph and does not move. pin is set to 65, and the airspeed + external compass on GPS are connected to the i2c splitter.
At a loss here - not sure how I can test to see if the airspeed sensor is actually broken or what..
Also seeing odd behavior where FBWA/B dips slightly left with no stick input (yes re-calibrated IMU's)
Also tried:
-reflashing firmware
-replacing all i2c cables
-tried new i2c splitter
-Enabled/disabled airspeed sensor with power cycled in between
-cycled through all available settings for pin for the hell of it (left at 65 now as instructions state).
Any help would be greatly appreciated!
Posts: 1
Participants: 1
