@davyg wrote:
I foolishly updated my 3DR Pixhawk to the latest firmware (not Beta), and afterwards I was left scratching my head and pulling out what little hair I have left...
the problem is this.... I did all the mandatory setup of hardware along with all failsafe and RTL switch along with the 3 pos flight mode.
when the Hexa is connected to MP flight data screen I can see that when the switch is thrown then STABILIZE -ALT HOLD-LOITER or RTL show up on screen.....However when I arm the hexa then only the STABILIZE -ALT HOLD will work and I get a double BEEP when trying to go to LOITER, and the RTL switch does nothing at all....
Now to cap it all the Pixhawk LED is always flashing AMBER after the initialization period is over...... I am so pissed at this I went back to firmware 3.2.1 .... bit of a pain really when an update causes so much hassle...
Posts: 10
Participants: 2