@lorbass wrote:
Origin Pixhawk, Taranis X9D, D16, RX X8R, Connected via SBUS.
Pixhawk configured for Gimbal Tilt as recommended in the Wiki (RC12 instead of RC9) as in the Pic.
In MP Windows "Tuning" the ch6in is moving according to the command on the TX.
But ch12out remains at Zero, and the servo does not move.
Tested with all Type of Gimbals in the selection of Gimbal configuration.Another test with the Pass Thru Function shows the same issue. No Output on the Aux Out's.
BRD_PWM_COUNT is set to 4
Attached the Parameter File
No Aux Out.param (8.5 KB)
Posts: 1
Participants: 1