@JStrz wrote:
This is my first post on this forum, so I want to say hello to all
I have a problem with the command COMMAND LONG - pixhawk with the firmware V3.4.1 arducopter.
I'm trying to get information for my OSD by sending MAV_CMD_SET_MESSAGE_INTERVAL. Always gets a response (by COMMAND_ACK) value of 3.
Is Command_Long is handled completely in this software ? (3.4.1)
Maybe someone can share dump, with correctly sent command_long data to pixhawk via uart?
I would add only as that by REQUEST_DATA_STREAM works OK, but because it has status deprecated - trying to use command_long.
Posts: 2
Participants: 2