Mission Planner bug in gimbal setup page?

@mike wrote:

I am having problems getting my new gimbal setup.

Pixhawk 3.4.4 firmware Octo coaxial
No gimbal control works

Install 3.4.4 quad
Safety switch disabled
Brd_safety bitmask disabled
All aux outputs set to PWM (6)
Gimbal setup page RCin6 tilt, RCin7 roll, RCin8 pan
RCout Tilt 6, Rcout7 roll Rcout8 pan. GImbal controls on Motor 6,Motor 7 and Motor 8
Everything works
Change Rcout Tilt 9, RCout Roll 10, RCout Pan 11, switch gimbal controls to aux 1, aux2, aux3 from Motor 6, Motor 7 Motor 8.
Everything works
Change Mnt_RC_IN_Tilt =9, MNT_RC_IN_Roll = 10, MNT_RC_IN_PAN =11
Everything Works
Load Octo coaxial firmware
Check settings remain as before, They are same settings.
Nothing Works.

Posts: 2

Participants: 1

Read full topic