@Arbutus wrote:
The Adafruit OLED SSD1306 display can apparently connect to the Pixhawk-1 via I2C.
I have flashed with 3.5-RC3 but cannot see any parameters that affect the display. For example NTF_DISPLAY_TYPE does not exist or is not available via QGCS 3.1.3 . There does not appear to be a parameter to address the device, enable or disable it.
What are the steps necessary to get this to work?
My setup:
Pixhawk-1 (2.4.8 h/w). I2C (0x3D) connected via I2C splitter shared with ext compass and Lidar (0x62). The OLED is from Adafruit - it is a monochrome 128x64px display, with solder jumpers to enable I2C or SPI. This is jumpered to I2C.
Posts: 1
Participants: 1
