@Thorsten wrote:
Hi all,
Yesterday I installed AC3.6dev on a new pixracer copter (APM:Copter V3.6-dev (f0f7ca23)). I was in the air for about 1.5 hours and all was fine. However, the savety switch LED was not solid. it was more a
Quick, constant blinking: Performing system check. Please wait.
as described in the wiki at: http://ardupilot.org/copter/docs/common-safety-switch-pixhawk.html
EKF2 was healthy, all flags ok. It was the same behaviour in all flights.
So my question is if this is a new behaviour, a bug or some issue with the copter?
If it is related to the copter setup, what should I look for?Thanks a lot in advance,
Thorsten
Posts: 5
Participants: 2