@Albi wrote:
Hi,
I'm having some trouble setting my Tx to produce the correct PWM values needed to select 6 flight modes using 2 switches. I'm using a Flysky FS-i6.
I've tried following this tutorial but when I go into AUX.CHANNELS I can only assign 1 switch to each channel. I'm assuming this is down to different firmware running on our devices.
This means I have to set this up using mixing and end point calibration which is something I know next to nothing about (my first Tx). If anyone could point me in the right direction, I'd very much appreciate it.I can set channel end points of the switch extremes and in the MIX settings, I can change:
Master Channel
Slave Channel
Pos. Mix
Neg. Mix
Offset
Posts: 2
Participants: 2
