@codeforge wrote:
Hi,
recently i bring out my 3dr apm board 2.6 with external gps and i want to make my skywalker x8 fly again. Then i download latest mission planner (not apm2 planner) and flash the board with latest firmware (3.6).
All done but when i connect the board and try to change flight mode i see only "INITIALIZING" and QLoiter, QRTL, Q...something. If then i connect my board to APM2 Planner i can see all flight modes. But i don't like so much APM2 Planner... Another issue is when i try to do Compass Motor calibration i get error when i push start and cannot do calibration. All other initial configuration found. I try to fly four times and using stabilize and auto mode and all is perfect. So i think apm 3.6 cannot connect to mission planner. Is correct? Can i get back using Mission Planner instead APM2 Planner?Thanks and sorry for lame question.
Posts: 2
Participants: 2