5 bips on fly 6 times in 1 mn flying?
@shyriu42 wrote: hello what does it mean 5 bips during flying on apm 2.8 ? 3 or 4 times in 1 mn ? what is the problem ? the quadcopter flying well but with this bips Posts: 2 Participants: 2 Read full...
View ArticleHow to set POI in the air - without MP
@sn0west wrote: Hi everyone, Is there a way to set the poi while the copter is in the air by switching a switch on the rc? I would like to use circle mode anytime I want. Hovering over an object set a...
View ArticleWeaving ground track
@hurzburg wrote: Flying APM in miniTalon....been working great in all modes including missions....however, today was a particularly windy day (25mph) and I noticed that cross wind tracks were slowly...
View ArticleCopter-3.5-rc1: LIDAR-Lite 3 Rangefinder No Signal
@lasakro wrote: After upgrading from 3.4.5, where the Rangefinder worked, to 3.5 RC1 it stopped working. I enabled EKF-3 with the same results. APM Planner 2.0.24 Quick Display no longer shows a...
View ArticleFail to download new firmware "The operation has timed out"
@mauritzg wrote: Hi Guys . Is there something wrong with the Firmware server? I'm getting a "The operation has timed out" when I try to download firmware in MP. Posts: 2 Participants: 2 Read full topic
View ArticleClik here to view.
Can't calibrate compass after I have already done it before
@mauritzg wrote: Has anyone came across this issue and know how to solve it. I'm busy setting up and Hexa with a Pixhawk. My first one was a APM 2.8 . I have gone through all the calibrations but for...
View ArticleTriggering a .py script from taranis
@pyrate wrote: I have apsync all working and have some basic .py scripts I want to test on board the Edisonbut cannot seem to find how to trigger a .py from the radio or GCSI know Kelly added a button...
View ArticleInterpreting a log to investigate toilet bowl effect
@flyingw wrote: Had a couple of flights today where I tested loiter mode. I observed some toilet bowl effect. What can Iearn to check in the log to see how to resolve the problem? I've attached the...
View ArticleClik here to view.
Tradheli from a beginners POV
@Implicit wrote: I've been flying fixed wing mapping planes for the last couple of years, but a few months back, Rob Lefebvre's Protcyon project caught my eye and I found the concept...
View ArticlePh2 joule carrier?
@fnoop wrote: Hi, is there any plan to change the edison carrier board to a joule? The joule has >50 times the performance of the edison and can undertake some serious work as a companion...
View ArticleClik here to view.
RC-Timer Mini ArduFlyer V1.0 Servo Range
@CrYo_ZA wrote: Hi Guys! My apologies for bothering you guys, my name is Rick and I am quite new here. I have been playing around a lot with different versions of the Pixhawk Flight controller as well...
View ArticleTakeoff in PositionHold?
@R_Q_Robert wrote: Hi AllI want to know is it possible to takeoff in PositionHold mode.?? Posts: 4 Participants: 4 Read full topic
View ArticleObject Avoidance
@Rusty_Jones wrote: So, not sure where to post this, as it could apply to all branches, so here goes. Object avoidance... I have been looking at some of the work that has been done lately, and it...
View ArticleQuestion about GPS on PX4
@Jason_strk wrote: I'm relatively new to all of this, Picked up a Pixhawk PX4 set on amazon but when I go into mission planner or Qground control the GPS module is not being detected. Is there a...
View ArticleClik here to view.
Question about mission planner
@Jason_strk wrote: is there a way to get to this screen with the newest version of mission planner? All I'm getting is the wizard option Posts: 3 Participants: 2 Read full topic
View ArticleBad optical flow health
@freaad wrote: Anyone can give the advice to solve the px4 flow bad optic health. I installed the firmware and I also install the laser sensor for distance sensor. I googled it yesterday but I can't...
View ArticleMissing Plane Icon and other Map Overlays
@Hamdhan777 wrote: Hello, I am having an issue with Mission Planner. Some of the text is missing and the icon (the plane icon with all the lines for heading etc) very rarely appears. Mission Planner...
View ArticleClik here to view.
FlightZoomer offers superb terrain awareness ontop of ArduPilot
@flightzoomer wrote: This is my first blog post on Ardupilot.org. Until now I usually posted news about my project in other blog spaces, but as my project strongly depends on ArduPilot as flight...
View ArticleClik here to view.
DEV call 27 Feb 2017 3pm PST = 27 Feb 2017 2300 UTC
@CraigElder wrote: UAVCAN https://github.com/ArduPilot/ardupilot/pull/5436 MAVlink https://github.com/ArduPilot/mavlink/pull/25 https://github.com/ArduPilot/mavlink/pull/26 AP_Sync Copter 3.5 Update...
View ArticleClik here to view.
Wifi range test Edison - TX1
@rbachtell wrote: I did a non-scientific range test today of an Edison with on board antenna and with external antenna as well as a comparison to the TX1. Tx1 was still sending telemetry when I got an...
View Article