Clik here to view.
Holybro Kakute F7 HDV and Tekko 32 F3 HDV 4-in-1 40A ESC Stack
@iSkyMaster wrote: Accidentally bought two of them for my DJI drone, so want to sell one. $115.00 image963×544 158 KB Posts: 1 Participants: 1 Read full topic
View ArticleClik here to view.
Futaba 14SG Airplane Radio MD2 Mode 2 FASST 2.4ghz RC Transmitter Only Version
@iSkyMaster wrote: In very good condition. I bought a Futaba 18Mz WC so this bad boy needs a new home. It’s been hardly used. Asking $578.00 Plus shipping. Futaba 14SG Airplane Version Transmitter,...
View ArticleClik here to view.
Futaba R617FS 7-Channel 2.4GHz FASST Receiver 7C # FUTL7627
@iSkyMaster wrote: I have two extra ones. I no longer need them, they are brand new. Asking $47.75 plus shipping. Posts: 1 Participants: 1 Read full topic
View ArticleClik here to view.
Skyzone SKY01S Diversity 5.8GHz 40CH FPV Goggles w/ Raceband
@iSkyMaster wrote: Partially Used. Asking $295.00 image518×648 118 KB |Innovative designed FPV Goggles from SkyZone The Skyzone FPV Goggles with built in 5.8GHz 40ch. video diversity bring your FPV...
View ArticleClik here to view.
RF Explorer 6G Combo Handheld Spectrum Analyzer - No Case
@iSkyMaster wrote: Asking $335 + Shipping. Bought it Brand new, but I no longer need it as I am using much more complex analyzer. image391×654 91.2 KB image549×830 143 KB |Product Information: RF...
View ArticlePlease add built in OSD inside PixHawk..and why it's not done yet?
@iSkyMaster wrote: Sorry in advance if I posted it in the wrong forum. May be its a pull request. Topic: PixHawk platform needs OSD badly Proposal type: Hardware [ X] , Software [ ] , Other [ ] :...
View ArticleMatek F405 CTR Frsky Telemetry with R9 slim+
@cyber_06_wolf wrote: I found a thread with someone using the RX1 (non-inverted) port with an f405 wing using serial_option 4, and matek’s website shows settings for the CTR using serial_option 7. I...
View ArticleTransmission: Power x Range
@tutstulio wrote: Hey guys!! I’m trying to study radio transmission. But I don’t get how power can influence the range. All I know is as greater the power, farter I can reach, but I’m searching for...
View ArticleClik here to view.
Crash without any indication
@koliver wrote: 1C6F4CB1-FD53-4df0-9031-947B089840831373×522 45.2 KB 3A855A87-4EFC-4feb-A4BB-D20809886BAE1662×758 43.6 KB 637D2FD8-7564-4083-A806-ABB2AB5056DC1425×613 37.4 KB I read the log and found...
View ArticleGeneral errors shuould have numbers and unical names and wikipage
@norim wrote: Hi the system of error messages is not perfect in ArduCopter. Every time I get an error message It’s hard to find information about it and messages are different in Mission Planner and...
View ArticleClik here to view.
Unable to find certain parameters
@iSkyMaster wrote: I am connected to my PixHawk and I am unable to a find a number of parameters under “Advance Paramters”, or “Full Paramter List”? My firmware is Ardu Plane. paramters I am looking...
View Article"JOYSTICK/RC OVERRIDE" or "JOYSTICK/MANUAL CONTROL" how is this determined
@mick wrote: I am trying to understand how APM Planner determines whether to forward joystick inputs from a GCS as “JOYSTICK/RC OVERRIDE” or “JOYSTICK/MANUAL CONTROL” as displayed in the APM Planner...
View ArticleDual Motor Delta Wing
@Potato_Chip wrote: Hi there, I’m Looking at putting an Cube Black with a mini carrier board inside this. On my setup with dual motors and dual ESC’s, wondered how on Earth I was going to set this up....
View ArticleClik here to view.
Small drone. motor burned (motor output log is included)
@HAESOLKIM wrote: Hello, I try to make indoor drone with two lidar(first lidar is downward for altitude and optical flow, second one for forward(or 360 lidar) to avoidance). However, The two motors...
View ArticleFlight stop after SET_POSITION_TARGET_GLOBAL_INT
@bull wrote: Hi All https://ardupilot.org/dev/docs/copter-commands-in-guided-mode.html#copter-commands-in-guided-mode-set-position-target-global-int I was flying with the...
View ArticleParachute Recovery System Failure Experiences
@BAS386 wrote: G’day my name is Bruce and I am doing some research into parachute recovery systems for UAS. I’ve looked at various commercial systems with different deployment methods (mechanical...
View ArticleQuestions on EKF
@eminakgn wrote: Hello everyone, I was reading EKF wiki page in ardupilot.org and I have few questions to people who have the knowledge. Sorry if my questions are too noob, in advance. I hope this is...
View ArticleHow to brake faster in PosHold similar to Loiter
@gnitzan wrote: Hi, I have noticed that when I fly fast in PosHold, copter keeps on going for about 10-15 meters when I let the stick jump to middle and I am sure I did not see the copter leaning...
View ArticleClik here to view.
Know more about circle mode
@Moksh wrote: Hello everyone I want to know more about circle mode , i know there is exist circle rate but i don’t have PC and laptop so all time I’m pushing in mobile app QGC. There is exits only...
View ArticleMy new build 550 drone with pixhawk starts rotating during flight and crashes
@robertocopter wrote: Hello, I have just finished building my first drone. It lifts off ok and seen to be stable ( I use stabalise mode). However after a few minutes in the air it is not controlable...
View Article