Throttle going to Zero when switch to AUTO, CRUISE, RTL Logs included
@Autonomost wrote: So my FBWA mode works well. I am using a IC engine on a plane. My receiver is a spektrum receiver and a DX9 transmitter. I checked the logs and it looks as though when it goes into...
View ArticleBluetooth re-connect
@wkf94025 wrote: Michael, As a bunch of us start using MP with Dragonlink v3 and its fully bidirectional telemetry, the issue of Bluetooth disconnect has come up. The connectivity between MP on laptop...
View ArticleMP Survey Grid issue
@achyutprao wrote: Hi, I am using Mission Planner Ver 1.3.38. We are using Sony A5100 camera & use the pic taken from it as sample photo for preparing the survey grid. We have permissions to fly...
View ArticleRequest Failsafe & AFS Attributes for Parachute
@GarrettMin wrote: Greetings, Request to attribute AFS & Failsafe Long actions:1. Action to Deploy the Parachute. 2. Action to Switch a Channel. Example if Failsafe then "Ignition Kill Switch on...
View ArticleClik here to view.
With no R/C receiver connnected, 3.4RC1 does not set Yaw, Pitch and Roll...
@rrr6399 wrote: I just tested 3.4RC1 with my R/C receiver disconnected from the Pixhawk. (We're only flying simple automated missions via the GCS.) During Guided Takeoff the copter will go to full...
View ArticleCheerson CX-20 and Tower APP issues
@Jesus_Mendez wrote: hi my cheerson CX20 does not arm motors (engines). APM present is 2.52 version. Is it compatible with tower app? thanks. Posts: 1 Participants: 1 Read full topic
View ArticleRequest Failsafe GPS
@GarrettMin wrote: Greetings, Request Failsafe GPS. Reason from time to time the GPS fails. Suggested action for GPS Fail is:1. Circle2. Parachute 3. Ignition Kill on RC Out Channel # Posts: 1...
View ArticleQuadcopter 3.4-dev Throw mode error
@geoffreybainathsah wrote: Hi Randy As i commented on your throw mode video.I am having issues with my copter not starting motors in throw mode. Let me explain my steps.lay craft on the floor >...
View ArticleWaypoint navigation suddenly stopped
@Lengua79 wrote: Hello everyone, A friend and I are trying to automate a 16' catamaran with two propellers, implementing ArduRover 3.0 Beta version . We're using SKID_STEERING_OUT = 1, and were able...
View ArticleQuadrotor Crash upon Entering AltHold
@AndersonRayner wrote: Hi, We've been using APM:Copter for a number of years now, and had our first crash which we can't diagnose the cause of. Any help would be much appreciated to work out what went...
View ArticleAc 3.3.3 battery failsafe
@Effy_Sh wrote: i tryed autotune on last weekend and after 14 min the pixhawk trigerd RTLi dont think the autotune finished even pitch .my setup:6s 10000maand failsafe was set to 21.6and reserved...
View ArticleBIN files for Quadplane Hover Tests Attached - Any Thoughts Before I Try...
@jacques_eloff wrote: I have uploaded the .bin files to Dropbox here: https://www.dropbox.com/s/8px9awlulb37387/57%2018-06-2016%2007-32-50.zip?dl=03 (dropbox account is not needed to retrieve) I'm...
View ArticleSolarStatus Plugin - beta test
@Mitar wrote: I made plugin for MP. It adds solar and earth magnetic field status (magnetic storm or solar storm)When the solar activity causes a magnetic storm, the functionalities of the drone’s GPS...
View ArticleQUAD slowly descends having no control and crashes three times
@micha3l19 wrote: APM 2.5 3DR Power Module EXTERNAL COMPASS ON STAND Flying for 2 years without any major problems This happened to me three times. Flying fine 3 to 4 lipos then i lose control over...
View Article"Bad gyro health" driving me crazy!
@xabdullahx wrote: In all its simplicity:If i install Copter 3.2.1, and try to callibrate accel, i will always get calibration failed.If i install Copter 3.0, i get calibration success, but on flight...
View ArticleClik here to view.
DO_VTOL_TRANSITION not working in QuadPlane simulation
@Ekci wrote: Hey, I'm simulation QuadPlane in SITL as described on ArduPlane page.The problem I have is that after writing a mission all DO_VTOL_TRANSITION commands changes to DO_REPEAT_SERVO. Do you...
View ArticleAPM 2.6 clone (APM2.8) with internal compass and external GPS/compass unit...
@cheekyleebo wrote: Hello everyone, I was hoping for a little help and advise. I am looking for the setup and calibration instructions to set up my APM2.8 whi has an internal compass and an external...
View ArticleI would like to read real time Efficiency in mAh/Km
@lanzo wrote: Hi, I saw the Pitlab OSD shows the efficiency in mAh/Km, this is very useful, for example if it's windy and you want to know you can complete the mission.Maybe MP can do it and estimate...
View ArticleClik here to view.
Disabling the climbing up in land mode
@cagiva851 wrote: I'm testing Copter-3.4 RC1 with the Navio2 indoors without GPS and I noticed that the vehicles climbs up (1-2 meters) when I switch from Alt-Hold to Land. I didn't experienced that...
View ArticleWhat are differences between NavEKF and NavEKF2
@Uncle wrote: I've searched in forums, but failed to find clear results. If it's already answered, please let me know the link...According src code, it uses EKF2 in px4-v1 and px4-v2, but enable EKF1...
View Article